Gold Ore Crusher

Gold ore processing production line equipment, including jaw crusher, ball mill, grading machine, magnetic separator, flotation machine, concentrator, dryer, etc., with the feeder, crane, belt conveyor can form a full set of gold ore mineral processing line The Through re-election, flotation, concentration and tailings extraction, and then purified by chemical methods, and finally through the smelting to form the final finished gold. The production line with high efficiency, low energy, large output, good benefits and so on.

1, gold ore processing process of gold ore crusher: The ore is transported from the loading and transportation equipment to the production line of the gold ore crusher. Feed to the jaw crusher of the original ore will be crushed into small pieces of ore, and then by cone crusher crushing, and eventually form about 0-10MM small particles, the whole crushing process is over.

2, gold ore processing process of gold ore grinding: In the first step, the gold ore has been crushed into small particles of 0-10 mm, already meet the delivery to the ore grinding machine, ball mill demand. In the hopper, vibrating feeder under the action of these small particles are uniformly conveyed to the mill for grinding, and then classifying by the classifier, hydrocyclone and other equipment, until all the gold powder to reach the next level the requirement of production and operation.

3, gold ore processing process of gold ore concentration, electrolysis, purification: Gold powder was purified by concentrator, into the CIL system with good chemical solvent, through the system, some of the tailings were excluded, concentrate was sent to the desorption electrolysis device, the final goal of gold can be obtained by melting.

Impact of gold ore crusher production capacity factors:

1. hardness of material. The harder the material is broken, the harder it becomes and the more severe the equipment wears. The crushing speed is slow, of course, the crushing capacity is small. This requires that we should be moderate in the choice of materials.

2. humidity of material. That is, when the moisture content in the material is large, the material is easy to adhere in the crusher, and it is easy to block in the process of feeding and conveying, resulting in less crushing capacity. To solve these problems, first of all in the material choice to strictly control the temperature of the material, if the choice of the material temperature is too large, can use sunlight or dried to reduce material moisture percentage.

3. fineness of materials after crushing. The fineness requirement is high, that is, the smaller the required material, the smaller the crushing capacity. This depends on the specific requirements of the concentrator, such as no special requirements, the general fineness of the material will be set to medium and fine.

4. composition of materials. Before crushing, the more fine powder in the material, the more it affects the crushing, because the fine powder is easy to adhere and influence the conveying. As a result, materials with fine powder content should be screened one time ahead of time. The fine powder as far as possible from the material screening, so as not to affect the normal work of the crusher.

5. viscosity of material. That is, the greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the crushing chamber in the crusher. If it can not be cleaned in time, it will seriously affect the working efficiency of the crusher, and will seriously affect the normal work of the crusher. Therefore, in the choice of materials, we must pay attention to the viscosity of the material can not be too large.

6. crushing equipment pieces (hammer, jaw plate) wear resistance, the greater the crushing capacity, if not wear-resistant, will affect the crushing capacity. In this regard, it is necessary to regularly repair the broken pieces of the crusher. In case of damage or damage, it will be replaced in time, so as not to affect the normal work of the crusher.